|
Ancillary Machine for Wire Drawing Plant
CONTINUOUS COILER
Continuous coiler is
used to get the non-stop production in a wire drawing plant. This
machine can be fitted just adjacent to the final block of the wire
drawing plant. Wire end from the final block is taken to the
continuous coiler. This machine has a stationary block on which is
cast in the form of a dead coil. Thus continuous coiler unwinds the
wire from immediately preceding block to give a dead cast coil. The
coil can be cut to any desired size and taken out for further
production without stopping the machine, which results in higher
production.
Power Required : 15 hp Motor.
Floor Space : 905 mm x 905 mm.
Approx. Nett Weight : 1694 kgs.
Approx. Gross Weight : 2202 kgs.
Case Size : 245 x 175 x 142 cms.
WIRE POINTING
MACHINE
Before the wire is
pushed through the die hole of wire drawing machine, to enter the
wire in the die it should be pointed at starting end, so that it can
pass through the die hole easily. The pointed end of the wire is
then pulled by means of pull-in tong in order to draw it.
Wire pointing machine is used to point starting end of wire. It has
two rollers having different sizes of grooves on their periphery. As
the machine starts, rollers rotate in opposite direction of each
other. End of the wire to be pointed is pushed between the two
rollers which tend to point the wire.
Rollers are made out of high quality alloy steel and are duly
hardened and ground to give longer working life.
Power Requirement : 3 hp Motor.
Floor Space : 360 mm x 510 mm.
Approx. Nett Weight : 319 kgs.
Approx. Gross Weight : 450 kgs.
Case Size : 89 x 77 x 140 cms.
MECHANICAL DESCALER
Mechanical Descaler is
used to remove the scales, from wire rod before it passes through
the first die. It is placed between flipping type pay-off device and
first block of Wire Drawing.
Basically, mechanical descaling is achieved by flexing the rod over
pulleys to break loose and remove the high temperature scale on the
rod.
Three horizontal and three vertical pulleys are given to flex the
wire rod and to remove the scales from the same.
These pulleys are made of high quality alloy steel duly hardened for
longer life and they run on standard size ball bearing for smooth
operation.
Floor Space : 1230 mm x 390 mm.
Approx. Nett Weight : 331 kgs.
Approx. Gross Weight : 496 kgs.
Case Size : 142 x 73 x 155 cms.
Your comments and
suggestions would help us to improve our services and products
more better.
Click Here to
Contact Us |
